DA084 PRESSURE COMPENSATION DEVICE
1.It has becomemore andmore important to provide a protected enclosure environment for valuable and crucial electrical and electronic components.
2.In a tightly closed enclosure, pressure differentials can occur during extreme temperature variations, such as day/night operation.
3.When this occurs, the risk of dust and humidity being absorbed into the control panel increases dramatically.
4.The specially designed pressure compensation device DA 084 permits a controlled change in pressure.
5.It can be installed easily in any enclosure. Because the pressure compensation plug’s high degree of protection(IP45), the protection type of the enclosure will not be affected.
PG 29 thread with union nut
5Nm (max. 10Nm)
plastic according to UL94 V-0, pebble grey
sealing gasket NBR
Ø 65.5mm x 30.5mm
-45 to +70°C (-49 to +158°F)
Make cut-out Ø 37+1mm in enclosure wall and mount pressure compensation device with nut. Please make sure that the sealing gasket is put in place on the outer side panel of the enclosure. For optimal pressure compensation we recommend to use two devices on opposite sides towards the top of the enclosure.
1 packing unit
If you would like a quotation or further information on this product, please fill in the form below and we will reply to you within 1 working day.