NTL-8000 MECHANICAL THERMOSTAT
Inner temperature controller for switchgear cabinet
Especially used for controlling fan filter, heater and exchanger, also could be monitoring the electric cabinetinner temperature when working as signal arcuser.
Make bimetal sensor as heat sensitivity set to feedback of heat.
Contact point scheme:single switch over contact point as instant switch component allowed load of contact point
(D)=sensitivity load at cos Φ=0.6
Adjusting range -20℃ to +60℃ Weight 105 gappr Size 70×70×33.5mm
● Swith discrepancy”1K±0.8K
● Voltage scope is wide, any type could be used from 24V to 230V
● Time-saving connection, terminal block could be installed with screw from outside
● Easy installation, could be installed to 35mm din rail vertically or horizontally. according to EN50022, it could be clipped to NS/35-ES cabinet profile with its accessory adapter.
If you would like a quotation or further information on this product, please fill in the form below and we will reply to you within 1 working day.